|
|
 |
|
·Ribs increase the bending stiffness of a part. Without ribs, the thickness has to be increased to increase the bending
stiffness. Adding ribs increases the moment of inertia, which increases the bending stiffness. Bending stiffness = E
(Young's Modulus) x I (Moment of Inertia) .
·The rib thickness should be less than the wall thickness-to keep sinking to a minimum. The thickness ranges from 40
to 60 % of the material thickness.In addition, the rib should be attached to the base with generous radiusing at the
corners.
·At rib intersections, the resulting thickness will be more than the thickness of each individual rib. Coring or some other
means of removing material should be used to thin down the walls to avoid excessive sinking on the opposite side.
·The height of the rib should be limited to less than 3 x thickness. It is better to have multiple ribs to increase the bending
stiffness than one high rib.
·The rib orientation is based on providing maximum bending stiffness. Depending on orientation of the bending load,
with respect to the part geometry, ribs oriented one way increase stiffness. If oriented the wrong way there is no
increase in stiffness.
·Draft angles for ribs should be minimum of 0.25 to 0.5 degree of draft per side.
If the surface is textured, additional 1.0 degree draft per 0.025 mm (0.001 inch) depth of texture should be provided.
|
|
